Polk Audio PA D5000.5 5 Channel Amplifier

Polk Audio

$799.00


Sleek, Compact, Powerful

The PA D5000.5 is capable of bridging two full-range channels into a single full-range channel with higher output power. For instance, the front channels (FL and FR) when wired correctly will increase the output power from 70W per channel to 200W per channel (for a 4 ohm load). The same can be done for the rear channels (RL and RR). The most common configurations are four full-range channels and a subwoofer channel, or two bridged full-range channels and a subwoofer channel.

PA D5000.5 Features:

・Super-efficient class D design—runs much cooler than conventional amps.
・High-speed MOSFET switching—power supply with outputs stable into 2 ohm loads for full range channel speakers and 1 ohm loads for subwoofer channel.
・Protection—thermal, DC offset, reverse DC voltage and short circuit protection.
・Sub 1/Sub 2 Inputs—line level inputs for subwoofer signal from head unit
・SUB/INT source switch—in the INT position, the amplifier will filter the bass frequencies from the full range signal and send them to the subwoofer amplifier channel.
・SUB sonic filter—attenuates the frequencies below the settings on the control.
・Remote bass level control—set gain to match output from head unit.
・Rear Full, HPF switch—selects between no filtering or a high pass filter to dial in your speakers' blending.
・Channel mode switch (4CH/ST)—in the ST position, the amplifier sends the same signal to the front and rear channels.
・Nickel-plated wire terminals & RCA connectors—ensure maximum signal transfer.
・Stainless steel hardware—Used throughout and will not corrode in humid environments.

Amplifier Power Specs

    RMS Power at 14.4V
        Watts per channel bridged - 4 ohms: 200 x 2 watts
        Watts per channel NOT bridged @ 1 kHz - 2 ohms: 100 x 4 watts
        Watts per channel NOT bridged @ 1 kHz - 4 ohms: 70 x 4 watts

Amplifier Specs

    12V & Ground Cable Gauge: 4AWG
    Channel Notes: Bridgeable Class D MOSFET
    Channels: 5

Power Specs

    100W x 4, 400W x 1 RMS @ 2 ohms
    70W x 4, 200W x 1 RMS @ 4 ohms
    200W x 2 RMS bridged @ 4 ohms
    500W x 1 RMS @ 1 ohm (sub)

Dimensions

    Depth: 6 3/4" (17.14cm)
    Height: 1 13/16" (4.60cm)
    Width: 13 5/16" (33.81cm)

Electrical

    Distortion at Rated Power: <0.1 %
    Max Sensitivity: 200mV-6V dB
    Minimum Impedance Bridged: 4 ohms
    Minimum Impedance Not Bridged: 2 ohms
    Protection Circuitry: Thermal, DC offset, reverse DC voltage and short circuit; fuses: two 40 Amp ATC
    Remote Gain: Yes, for bass
    Signal-to-noise (Referenced to rated power): 105 dBA
    Subsonic Filter: Yes
    Total Frequency Response: 20Hz-20kHz
    High Pass Filter - Filter Frequency: 40Hz-400Hz(front)/40Hz-4kHz(rear)
    High Pass Filter - Filter Slope: 12dB/octave
    Low Pass Filter - Filter Frequency: 80Hz-4kHz(front)


More from this collection