Polk Audio PA D1000.1 Mono Amplifier
Sleek, Compact, Powerful, and Really Cool
The PA D1000.1 offers an ultra-compact, minimalist design. A toroidal transformer helps keep the amplifier's sleek aluminum extruded design under 2-inch tall while ensuring plenty of clean, efficient power. A low THD, a high signal-to-noise ratio, plus wide bandwidth frequencies, make the new PA D1000.1 a high performance monoblock for high performance bass.
PA D1000.1 Features
Super-efficient class D design—runs much cooler than conventional amps.
High-speed MOSFET switching—Power supply with outputs stable into 1 ohm loads.
Protection—Thermal, DC offset, reverse polarity and short circuit protection.
Variable low-pass filter: 40 Hz-220 Hz.
Variable subsonic filter: 20 Hz-38 Hz.
Bass boost at 0 dB-12 dB.
Bass boost at 44 Hz.
Remote subwoofer level control.
Nickel-plated wire terminals & RCA connectors—Ensure maximum signal transfer.
Level control—adjusts the gain of the channel to match the output voltage from your head unit.
Line level outputs—provides a full range signal for easy connection to additional amplifiers.
Stainless steel hardware—used throughout the box!
Amplifier Power Specs
RMS Power at 14.4V
Watts per channel NOT bridged @ 1 kHz - 1 ohm: 1200 watts
Watts per channel NOT bridged @ 1 kHz - 2 ohms: 800 watts
Watts per channel NOT bridged @ 1 kHz - 4 ohms: 500 watts
12V & Ground Cable Gauge: 4AWG
Bass Boost Characteristics: 44Hz Hz
Channel Notes: Class D MOSFET
Depth: 6 3/4" (17.14cm)
Height: 1 13/16" (4.60cm)
Width: 12 15/16" (32.86cm)
Distortion at Rated Power: <0.1 %
Effective Damping Factor: >150
Max Sensitivity: 200mV-6V dB
Minimum Impedance Not Bridged: 1 ohms
Protection Circuitry: Thermal, DC offset, reverse polarity and short circuit; three 30 Amp ATC fuses
Remote Gain: Yes
Signal-to-noise (Referenced to rated power): 105 dBA
Subsonic Filter: 20Hz-38Hz
Total Frequency Response: 20Hz-200Hz
Low Pass Filter - Filter Frequency: 40Hz-220Hz
Low Pass Filter - Filter Slope: 12dB/octave